MECHANICAL PIPING ENGINEER DUNCAN AND ROSS MANAGEMENT CONSULTANCIES

Supervision & Oversight:

• Review and monitor EPC Contractors piping design deliverables, including isometrics, GA drawings, stress analysis, and material specifications.
• Review design elements for gas/steam turbines, HRSG, condensers, pumps, valves, and auxiliary mechanical equipment.
• Ensure compliance with applicable industry codes and standards (ASME, ASTM, EN).
• Validate technical solutions for piping routing, pipe supports, and equipment interfaces.

Construction Monitoring:

• Supervise piping fabrication and erection at site.
• Ensure installation follows approved drawings, procedures, and quality plans.
• Review and comment on Method Statements and ITPs.
• Participate in inspections and witness testing such as hydrotests, flushing, and NDT.

Quality & Safety:

• Monitor workmanship quality, identify non-conformances, and follow up on corrective actions.
• Promote and enforce HSSE standards; participate in safety walks and Toolbox Talks.
• Take active responsibility for personal and team safety, adhering to all HSSE requirements.
• Report unsafe acts, hazards, incidents, or near misses immediately.

Progress & Coordination:

• Track and report progress of piping activities, identifying risks or schedule delays.
• Coordinate with civil, mechanical, electrical, and other engineering disciplines.
• Support resolution of technical queries and construction challenges.

Documentation & Handover:

• Review as-built documents, test reports, and turnover packages.
• Ensure all documentation is complete for project close-out and commissioning readiness.

Reporting:

• Prepare weekly progress reports outlining key issues, risks, and achievements.
• Comply with all safe work instructions, permit requirements, and HSSE procedures.
• Attend required HSSE training, toolbox meetings, and internal coordination sessions.