Clerk Production Inspector Production Facility

LEONI Wiring System Egypt S.A.E

Inspects products in line with internal QM standards and control plans

- Accomplishes specific tasks within the Assembly area, (e.g. representative not full list)

- Performs all checks as defined in the Quality control plan and records the required data

- Identifies non-conforming products with "red card" process

- Distributes and collects PDEK or other control charts

- Gives feedback to line and to WPA for all non-conformities found on the assembly line (e.g. electrical test, clip test, inspection points, care points, etc.) by using the stop at first defect process

- Inspects 5S / housekeeping application within the area of responsibility

- Identifies areas of product risk e.g. material on the floor, terminals damaged, bent within holders, stands, mixed components, etc.

- Checks that operators are qualified to work on the station in line with the skills matrix

- Checks adherence to OK to Start procedure at the start of each shift

- Performs check of error proofing conformity within the assembly area (e.g. good/bad sample test release, poka- yoke, jigs, etc.)

- Varifies that assembly aid tools are available and used in proper condition (e.g. convolute and corrugated tube aids, pvc tube aids, etc.)

- Validates the completion of the packing process and conformity according to work instructions

- Ensures that in-line and off-line reworks are performed by qualified operators with released tools and respecting rework procedures

- Inspects if documentation in workstation according to control plan and internal standards is followed

- Audits final harness inspection in accordance with the QM plan and or additional care points